AudioCodes Mediant 500L - Page 717

Version 7.2 717 Mediant 500L Gateway & E-SBC
User's Manual 36. SBC Manipulations
Parameter Description
ngPolicyName]
If only one Routing Policy is configured in the Routing Policies table,
the Routing Policy is automatically assigned. If multiple Routing
Policies are configured, no value is assigned.
To configure Routing Policies, see ''Configuring SBC Routing Policy
Rules'' on page 705.
Note: The parameter is mandatory.
General
Index
[IPInboundManipulation_Index
]
Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
Name
manipulation-name
[IPInboundManipulation_Mani
pulationName]
Defines an arbitrary name to easily identify the manipulation rule.
The valid value is a string of up to 20 characters. By default, no valu
e
is defined.
Additional Manipulation
CLI: is-additional-manipulation
[IPInboundManipulation_IsA
dditionalManipulation]
Determines whether additional SIP URI user part manipulation is
done for the table entry rule listed directly above it.
 [0] No = (Default) Regular manipulation rule (not done in addition
to the rule above it).
 [1] Yes = If the above row entry rule matched the call, consider
this row entry as a match as well and perform the manipulation
specified by this rule.
Note: Additional manipulation can only be done on a different SIP
URI, source or destination, to the rule configured in the row above as
configured by the 'Manipulated URI' parameter (see below).
Manipulation Purpose
CLI: purpose
[IPInboundManipulation_Ma
nipulationPurpose]
Defines the purpose of the manipulation:
 [0] Normal = (Default) Inbound manipulations affect the routing
input and source and/or destination number.
 [1] Routing input only = Inbound manipulations affect the routing
input only, retaining the original source and destination number.
 [2] Shared Line = Used for the Shared-Line Appearance feature.
This manipulation is for registration requests to change the
destination number of the secondary extension numbers to the
primary extension. For more information, see ''Configuring
BroadSoft's Shared Phone Line Call Appearance for Survivability''
on page 760.
Match
Request Type
CLI: request-type
[IPInboundManipulation_Re
questType]
Defines the SIP request type to which the manipulation rule is
applied.
 [0] All = (Default) All SIP messages.
 [1] INVITE = All SIP messages except REGISTER and
SUBSCRIBE.
 [2] REGISTER = Only REGISTER messages.
 [3] SUBSCRIBE = Only SUBSCRIBE messages.
 [4] INVITE and REGISTER = All SIP messages except
SUBSCRIBE.
 [5] INVITE and SUBSCRIBE = All SIP messages except
REGISTER.