AudioCodes Mediant 500L - Page 718

User's Manual 718 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
Source IP Group
CLI: src-ip-group-name
[IPInboundManipulation_Src
IpGroupName]
Defines the IP Group from where the incoming INVITE is received.
The default is Any (i.e., any IP Group).
Source Username Prefix
CLI: src-user-name-prefix
[IPInboundManipulation_Src
UsernamePrefix]
Defines the prefix of the source SIP URI user name (usually in the
From header).
The default is the asterisk (*) symbol (i.e., any source username
prefix).
Note: The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 999.
Source Host
CLI: src-host
[IPInboundManipulation_Src
Host]
Defines the source SIP URI host name - full name (usually in the
From header).
The default is the asterisk (*) symbol (i.e., any host name).
Destination Username Prefix
CLI: dst-user-name-prefix
[IPInboundManipulation_De
stUsernamePrefix]
Defines the prefix of the destination SIP URI user name, typically
located in the Request-URI and To headers.
The default is the asterisk (*) symbol (i.e., any destination username
prefix).
Note: The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 999.
Destination Host
CLI: dst-host
[IPInboundManipulation_De
stHost]
Defines the destination SIP URI host name - full name, typically
located in the Request URI and To headers.
The default is the asterisk (*) symbol (i.e., any destination host
name).
Operation Rule - Action
Manipulated Item
CLI: manipulated-uri
[IPInboundManipulation_Ma
nipulatedURI]
Determines whether the source or destination SIP URI user part is
manipulated.
 [0] Source = (Default) Manipulation is done on the source SIP
URI user part.
 [1] Destination = Manipulation is done on the destination SIP URI
user part.
Remove From Left
CLI: remove-from-left
[IPInboundManipulation_Re
moveFromLeft]
Defines the number of digits to remove from the left of the user na
me
prefix. For example, if you enter 3 and the user name is "john", the
new user name is "n".
Remove From Right
CLI: remove-from-right
[IPInboundManipulation_Re
moveFromRight]
Defines the number of digits to remove from the right of the user
name prefix. For example, if you enter 3 and the user name is "john",
the new user name is "j".
Note: If both 'Remove From Right' and 'Leave From Right'
parameters are configured, the 'Remove From Right' setting is
applied first.
Leave From Right
CLI: leave-from-right
[IPInboundManipulation_Le
aveFromRight]
Defines the number of characters that you want retained from the
right of the user name.
Note: If both 'Remove From Right' and 'Leave From Right'
parameters are configured, the 'Remove From Right' setting is
applied first.