AudioCodes Mediant 500L - Page 723

Version 7.2 723 Mediant 500L Gateway & E-SBC
User's Manual 36. SBC Manipulations
Parameter Description
[IPOutboundManipulation_M
essageConditionName]
Condition Rules'' on page 421.
ReRoute IP Group
re-route-ip-group-name
[IPOutboundManipulation_R
eRouteIPGroupName]
Defines the IP Group that initiated (sent) the SIP redirect response
(e.g., 3xx) or REFER message. The parameter is typically used for re-
routing requests (e.g., INVITEs) when interworking is required for SIP
3xx redirect responses or REFER messages.
The default is Any (i.e., any IP Group).
Note:
 The parameter functions together with the 'Call Trigger' parameter
(see below).
 For more information on interworking of SIP 3xx redirect responses
or REFER messages, see ''Interworking SIP 3xx Redirect
Responses'' on page 656 and ''Interworking SIP REFER
Messages'' on page 659, respectively.
Action
Manipulated Item
manipulated-uri
[IPOutboundManipulation_Is
AdditionalManipulation]
Defines the element in the SIP message that you want manipulated.
 [0] Source URI = (Default) Manipulates the source SIP Request-
URI user part.
 [1] Destination URI = Manipulates the destination SIP Request-URI
user part.
 [2] Calling Name = Manipulates the calling name in the SIP
message.
Remove From Left
remove-from-left
[IPOutboundManipulation_R
emoveFromLeft]
Defines the number of digits
to remove from the left of the manipulated
item prefix. For example, if you enter 3 and the user name is "john",
the new user name is "n".
Remove From Right
remove-from-right
[IPOutboundManipulation_R
emoveFromRight]
Defines the number of digits to remove from the right of the
manipulated item prefix. For example, if you enter 3 and the user
name is "john", the new user name is "j".
Leave From Right
leave-from-right
[IPOutboundManipulation_L
eaveFromRight]
Defines the number of digits to keep from the right of the manipulated
item.
Prefix to Add
prefix-to-add
[IPOutboundManipulation_Pr
efix2Add]
Defines the number or string to add in the front of the manipulated
item. For example, if you enter 'user' and the user name is "john", the
new user name is "userjohn".
If you set the 'Manipulated Item' parameter to Source URI or
Destination URI, you can configure the parameter to a string of up 49
characters. If you set the 'Manipulated Item' parameter to Calling
Name, you can configure the parameter to a string of up 36
characters.
Suffix to Add
suffix-to-add
[IPOutboundManipulation_S
uffix2Add]
Defines the number or string to add at the end of the manipulated
item. For example, if you enter '01' and the user name is "john", the
new user name is "john01".
If you set the 'Manipulated Item' parameter to Source URI or
Destination URI, you can configure the parameter to a string of up 49