User's Manual 722 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
user names, you can use tags (see 'Source Tags' parameter below)
instead of this parameter.
Source Host
src-host
[IPOutboundManipulation_Sr
cHost]
Defines the source SIP URI host name - full name, typically in the
From header.
The default value is the asterisk (*) symbol (i.e., any source host
name).
Source Tags
src-tags
[IPOutboundManipulation_Sr
cTags]
Assigns a prefix tag to denote source URI user names corresponding
to the tag configured in the associated Dial Plan.
The valid value is a string of up to 20 characters. The tag is case
insensitive.
To configure prefix tags, see ''Configuring Dial Plans'' on page 726.
Note:
Make sure that you assign the Dial Plan in which you have
configured the prefix tag, to the related IP Group or SRD.
Instead of using tags and configuring the parameter, you can use
the 'Source Username Prefix' parameter to specify a specific URI
source user or all source users.
Destination Username Prefix
dst-user-name-prefix
[IPOutboundManipulation_D
estUsernamePrefix]
Defines the prefix of the destination SIP URI user name, typically
located in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any destination
username prefix). The prefix can be a single digit or a range of digits.
For available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 999.
Note:
If you need to manipulate calls of many different destination URI
user names, you can use tags (see 'Destination Tags' parameter
below) instead of this parameter.
Destination Host
dst-host
[IPOutboundManipulation_D
estHost]
Defines the destination SIP URI host name - full name, typically
located in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any destination host
name).
Destination Tags
dest-tags
[IPOutboundManipulation_D
estTags]
Assigns a prefix tag to denote destination URI user names
corresponding to the tag configured in the associated Dial Plan.
The valid value is a string of up to 20 characters. The tag is case
insensitive.
To configure prefix tags, see ''Configuring Dial Plans'' on page 726.
Note:
Make sure that you assign the Dial Plan in which you have
configured the prefix tag, to the related IP Group or SRD.
Instead of using tags and configuring the parameter, you can use
the 'Destination Username Prefix' parameter to specify a specific
URI destination user or all destinations users.
Calling Name Prefix
calling-name-prefix
[IPOutboundManipulation_C
allingNamePrefix]
Defines the prefix of the calling name (caller ID). The calling name
appears in the SIP From header.
The valid value is a string of up to 37 characters. By default, no prefix
is defined.
Message Condition
message-condition-name
Assigns a Message Condition rule as a matching characteristic.
Message Condition rules define required SIP message formats.
To configure Message Condition rules, see ''Configuring Message
To Next Page
Loading...
