AudioCodes Mediant 500L - Page 721

Version 7.2 721 Mediant 500L Gateway & E-SBC
User's Manual 36. SBC Manipulations
Parameter Description
anipulationName]
is defined.
Additional Manipulation
is-additional-manipulation
[IPOutboundManipulation_Is
AdditionalManipulation]
Determines whether additional manipulation is done for the table entry
rule listed directly above it.
 [0] No = (Default) Regular manipulation rule - not done in addition
to the rule above it.
 [1] Yes = If the previous table row entry rule matched the call,
consider this row entry as a match as well and perform the
manipulation specified by this rule.
Note: Additional manipulation can only be done on a different item
(source URI, destination URI, or calling name) to the rule configured in
the row above (configured by the 'Manipulated URI' parameter).
Call Trigger
trigger
[IPOutboundManipulation_Tr
igger]
Defines the reason (i.e., trigger) for the re-routing of the SIP request:
 [0] Any = (Default) Re-routed for all scenarios (re-routes and non-
re-routes).
 [1] 3xx = Re-routed if it triggered as a result of a SIP 3xx response.
 [2] REFER = Re-routed if it triggered as a result of a REFER
request.
 [3] 3xx or REFER = Applies to options [1] and [2].
 [4] Initial only = Regular requests that the device forwards to a
destination. In other words, re-routing of requests triggered by the
receipt of REFER or 3xx does not apply.
Match
Request Type
request-type
[IPOutboundManipulation_R
equestType]
Defines the SIP request type to which the manipulation rule is applied.
 [0] All = (Default) all SIP messages.
 [1] INVITE = All SIP messages except REGISTER and
SUBSCRIBE.
 [2] REGISTER = Only SIP REGISTER messages.
 [3] SUBSCRIBE = Only SIP SUBSCRIBE messages.
 [4] INVITE and REGISTER = All SIP messages except
SUBSCRIBE.
 [5] INVITE and SUBSCRIBE = All SIP messages except
REGISTER.
Source IP Group
src-ip-group-name
[IPOutboundManipulation_Sr
cIPGroupName]
Defines the IP Group from where the INVITE is received.
The default value is Any (i.e., any IP Group).
Destination IP Group
dst-ip-group-name
[IPOutboundManipulation_D
estIPGroupName]
Defines the IP Group to where the INVITE is to be sent.
The default value is Any (i.e., any IP Group).
Source Username Prefix
src-user-name-prefix
[IPOutboundManipulation_Sr
cUsernamePrefix]
Defines the prefix of the source SIP URI user name, typically used in
the SIP From header.
The default value is the asterisk (*) symbol (i.e., any source username
prefix). The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 999.
Note: If you need to manipulate calls of many different source URI