AudioCodes Mediant 500L - Page 74

User's Manual 74 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
User Level
Numeric
Representation in
RADIUS
Privileges
except the last Security Administrator.
Note: Only Master users can delete Master users. If only
one Master user exists, it can be deleted only by itself.
Administrator
100 Read/write privileges for all Web pages, except security-
related pages and the Local Users table where this user
has read-only privileges.
Monitor
50 Read-only privileges and access to security-related pages
is blocked.
Note: Only Security Administrator and Master users can configure users in the Local
Users table. Administrator users have read-only privileges and Monitor users are
denied access to the table. However, Administrator and Monitor users can change
their login credentials in the Web Settings page (see ''Configuring Web Session and
Access Settings'' on page 79).
By default, the device is pre-configured with the following two user accounts:
Table 6-6: Default User Accounts
User Level Username
(Case-Sensitive)
Password
(Case-Sensitive)
Security Administrator
"Admin" "Admin"
Monitor
"User" "User"
Note:
• For security, it's recommended that you change the default username and
password of the default users.
• To restore the device to the default users (and with their default usernames and
passwords), configure the ini file ResetWebPassword parameter to 1. If you have
configured any other accounts, they are deleted.
• If you delete a user who is currently in an active Web session, the user is
immediately logged off the device.
• Up to five users can be concurrently logged in to the Web interface; they can all be
the same user.
• You can set the entire Web interface to read-only (regardless of Web user access
levels), using the ini file parameter DisableWebConfig (see ''Web and Telnet
Parameters'' on page 1003).
• You can define additional Web user accounts using a RADIUS server (see
''RADIUS Authentication'' on page 244).
The following procedure describes how to configure user accounts through the Web
interface. You can also configure it through ini file (WebUsers) or CLI (configure system >
user).
 To configure management user accounts:
1. Open the Local Users table (Setup menu > Administration tab > Web & CLI folder >