AudioCodes Mediant 500L - Page 75

Version 7.2 75 Mediant 500L Gateway & E-SBC
User's Manual 6. Web-Based Management
Local Users).
2. Click New; the following dialog box is displayed:
Figure 6-30: Local Users Table - Dialog Box
3. Configure a user account according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 6-7: Local Users Table Parameter Descriptions
Parameter Description
General
Index
[WebUsers_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Username
user
[WebUsers_Username]
Defines the Web user's username.
The valid value is a string of up to 40 alphanumeric characters,
including the period ".", underscore "_", and hyphen "-" signs.
Password
password
[WebUsers_Password]
Defines the Web user's password.
The valid value is a string of 8 to 40 ASCII characters. To ensure
strong passwords, adhere to the following password complexity
requirements:
 Contain at least eight characters.
 Contain at least two letters that are upper case (e.g., A).
 Contain at least two letters that are lower case (e.g., a).
 Contain at least two numbers (e.g., 4).
 Contain at least two symbols (non-alphanumeric characters) (e.g.,
$, #, %).
 No spaces.
 Contain at least four new characters that were not used in the
previous password.
Note:
 To enforce the password complexity requirements mentioned
above, configure the EnforcePasswordComplexity to 1.
 For security, password characters are not shown in the Web
interface and ini file. In the Web interface, they are displayed as
dots when you enter the password and then once applied, the