Programming System Options
Pool Programming
4-51
Considerations 4
■ For extension 10 and any extensions for which Line Access Mode (#313) is set to Key, this
feature is automatically set to No Access.
■ When a user has access to a pool for outgoing calls, you can customize dialing restrictions for
the user’s extension by using Outgoing Call Restriction (#401) and Disallowed Phone
Number Lists (#404).
■ To restrict a pooled extension from receiving and/or making calls on individual lines, you must
use Line Access Restriction (#302).
■ Caller ID information does not appear for ringing calls on lines belonging to a pool
programmed for Out Only or for No Access.
Programming 4
To restrict an extension from making or receiving calls on all the lines in a specific pool:
1. Press
f00ss#315.
2. Enter the number of the extension to be programmed. A display similar to the following
appears:
Pool Access Rstr 23
Pool:
3. Enter the pool number (880, 881, 882, or 883) to be restricted at this extension. The current
restriction is displayed.
4. Press
D until the appropriate value appears:
■ 1 = No Restriction (calls permitted on all lines in that pool; the factory setting)
■ 2 = Out Only (can only make outside calls, not receive them, on lines in that pool)
■ 3 = In Only (can only receive calls, not make them, on lines in that pool)
■ 4 = No Access (cannot receive or make calls, but can receive transferred calls on lines in
that pool)
5. Do one of the following:
■ To restrict another pool at this extension, press n or p until the pool number
shows on the display. Then repeat Step 4.
■ To restrict another extension, press N or P and begin at Step 2.
6. Select another procedure, or exit programming mode.
To Next Page
Loading...
