Introduction to MICROBEAST PLUS HD
the switch is not connected MICROBEAST PLUS HD is switched on permanently as soon
as the power is connected.
Please note:
• Using the high power connection port is not a must. You can also use MICROBEAST
PLUS HD in a conventional manner by powering the unit from the receiver ports in the
top row, as shown in the chapter on receiver installation
1
. However, using the electronic
power switch system is not possible then!
• The electrical connections of the high power connection port and the upper terminal row
form a parallel power circuit during operation. So it is possible to connect an additional
power source at the upper terminal row. For example this can be a buffering battery or a
backup system that shall protect against failure of the primary power source. In this case
note the manufacturer‘s instructions, if this is possible and permissible for the supply
systems used. Also note that using the electronic power switch system of MICROBEAST
PLUS HD is not possible in this combination!
• Note that the system can only be as powerful as the power source allows. Use power
cables with sufficient diameter, avoid long cable length and only use a plug system for
connection of battery and power cable that is capable of transferring high currents.
• MICROBEAST PLUS HD does not supply an internal voltage regulation! The voltage
that is applied to the high power connection port will directly be passed to the servo
and receiver connections. Only use electronic components (servos and receiver) that are
designed for your power source.
MICROBEAST PLUS HD will draw a very low amount of current even when the
system is switched off! Therefore always completely disconnect the battery from
the system if you do not use the model for a extended period of time to
prevent the supply battery from getting discharged and damaged in consequence.
1
https://wiki.beastx.com/./index.php/Manuals:MB_Plus:Receiver_Installation
32
To Next Page
Loading...
