Bernina 790 PRO - Sewing Eyelets

Buttonholes
122
> Lower the presser foot.
> Perform the first stitches in the left hole via the handwheel.
> Keep turning the handwheel until the needle changes to the right hole. In doing so, check whether the
needle goes into the right hole. If necessary, adjust the stitch width by turning the upper Multifunction
knob.
> Hold the threads and push the foot control.
– The machine sews on the button and stops automatically.
> For increased stability, sew the Button sew-on Program again.
> Cut the threads with the machine. Alternatively, pull the sewing projects from under the sewing machine
and trim the threads by hand. Pull the upper thread to the wrong side of the fabric and knot it with the
bobbin thread.
9.17 Sewing Eyelets
For increased stability sew the eyelet twice. Adjust stitch with the balance if necessary.
• The Reverse Pattern Foot#1C or the Open Embroidery Foot#20C is fitted.
> Tap «Buttonholes».
> Select Eyelet with Small Zigzag61 or Eyelet with Straight Stitch62.
> Turn the, «Upper Multi-function Knob» or «Lower Multi-function Knob» to alter the size of the eyelet.
> Sew the Eyelet Program.
– The machine stops automatically at the end of the Eyelet Program.
> Use an awl, punch pliers or a hole punch to open the eyelet.