Errors and Faults
182
18 Errors and Faults
18.1 Error Messages
Message on the Display Cause Solution
Stitch number unknown. > Check the entry and enter the new number.
Selection of stitch patterns not
possible in Combi-mode.
> Combine other stitch patterns.
The feed dog is not lowered. > Push the button «Feed Dog Up/Down» to lower the
feed dog.
The selected needle and stitch
plate cannot be used in
combination.
> Replace the needle.
> Replace the stitch plate.
The selected presser foot does
not match with the fitted presser
foot.
> Select the fitted presser foot in the presser foot selection
or change the presser foot.
The needle is not at its top end. > Adjust the needle position via the handwheel.
The upper thread is used up. > Rethread.
The upper thread has broken. > Rethread.
To Next Page
Loading...
