Sewing Preparation
40
Using the Seam Guide
The seam guide for the slide-on table facilitates sewing of evenly wide edges and hems.
• The slide-on table has been fitted.
> Touch the release button and engage the seam guide from the front to the back on the slide-on table.
> To determine the edge width, press the release button and move the seam guide to the right or left.
> Touch the release button and pull the seam guide away to the front.
2.8 Presser Foot
Adjusting the Presser Foot Position via the Knee Lifter of the Free Hand System
> Adjust the sitting height so that the knee lifter can be operated with the knee.
> Push the knee lifter with the knee to the right to raise the presser foot.
– Simultaneously the feed dog is lowered and the thread tension is released.
> Release the knee lifter slowly to lower the presser foot.
Adjusting the Presser Foot Position via the Button «Presser Foot Up/Down»
> To raise the presser foot, push the button «Presser Foot Up/Down».
> To lower the presser foot, push the button «Presser Foot Up/Down» again.
Changing the Presser Foot
> Raise the needle.
> Raise the presser foot.
> Switch off the machine.
> Push the clamping lever up.
> Remove the presser foot.
> Guide the new presser foot upwards over the cone.
> Press the clamping lever down.
To Next Page
Loading...
