Bernina 790 PRO - Adjusting the Needle Position Up;Down; Adjusting the Needle Position Left;Right; Needle Stop Up;Down (Permanent)

Sewing Preparation
43
> Select the needle type (2) of the fitted needle.
1
2
Adjusting the Needle Position Up/Down
> To lower the needle, push the button «Needle position Up/Down».
> To raise the needle, push the button «Needle position Up/Down» again.
Adjusting the Needle Position Left/Right
There is a total of 11 needle positions. The needle position is indicated by the needle position number in the
display.
> To position the needle position to the left, push the button «Needle Position Left»(1).
> To position the needle position to the right, push the button«Needle Position Right»(2).
1 2
Needle Stop Up/Down (Permanent)
> To set the needle stop position permanently, tap «Needle Stop Up/Down».
– The machine stops with needle position down as soon as the foot control is released or the button
«Start/Stop» has been pushed.
> Tap «Needle Stop Up/Down» again.
– The machine stops with needle position up as soon as the foot control is released or the button
«Start/Stop» has been pushed.