Bernina 790 PRO - Page 129

BERNINA Stitch Regulator (BSR)
129
> Tap «KickStart».
– The KickStart display appears. The selected BSR Mode is displayed.
> To start the machine, press the foot control briefly with your heel.
– The machine starts sewing with the selected settings as soon as the fabric is moved.
> To stop the machine, press the foot control briefly with your heel again.
– The machine will stop, but the KickStart function will remain active.
> To end the KickStart function, tap the screen or press the foot control at the front.
– The BSR display appears.
– The KickStart function will be deactivated.
– The function programmed for the Back-kick will be active.
Please note
• While the KickStart function is active, the function programmed for Back-kick is deactivated. The Back-
kick then only serves to start and stop the machine.
• The KickStart function will be ended immediately if the active monitoring function reports an error (e.g.
thread breakage or bobbin empty).
• The KickStart function will be ended immediately if the foot control cable is unplugged.
• f there is no sewing in BSR Modes, the machine goes into Stand-by Mode after 7seconds. Exit the Stand-
by Mode by pressing the heel again.
• If no sewing is done for up to 60seconds, the KickStart function is automatically terminated. The
KickStart display disappears.