Brunswick MAX - Page 101

MAX Operation & Service Manual 101MAX Operation & Service Manual Section 6: Maintenance & Service 101
7. Inspect duster contact roller for shrinkage, chunks, dents, or brittleness and inspect hardware
for wear. Replace as needed.
.
8. Inspect duster up/down switches for damage and replace if needed.
9. Inspect dispersion roller for damage, check chain tension and repair, replace, or adjust if
needed.
10. Remove cleaner spray nozzles and check valve lters. Clean all by soaking in a distilled white
vinegar for 30 minutes, rinse with warm water and blow out with compressed air.
WARNING! Wear safety glasses when using compressed air. Place a cloth
underthespraytipassemblytoabsorbresidualuidthatmaydripwhen
removing tips.
11. Inspect traction drive chain alignment and tension and adjust if needed.