Brunswick MAX - Section 1: Safety; Notes and Warnings; Safety Notice to Users of this Manual

6 MAX Operation & Service Manual6 Section 1: Safety MAX Operation & Service Manual
Section 1: SAFETY!
NOTES & WARNINGS
Throughout this publication, “Warnings”, and “Cautions” (accompanied by one of the International
HAZARD Symbols) are used to alert the mechanic to special instructions concerning a particular
service or operation that may be hazardous if performed incorrectly or carelessly. They are dened
below. OBSERVE AND READ THEM CAREFULLY!
These “Safety Alerts” alone cannot eliminate the hazards that they signal. Strict compliance to these
special instructions when performing the service, along with training and “Common Sense” operation,
are major accident prevention measures.
NOTEorIMPORTANT!:Willdesignatesignicantinformationalnotes.
WARNING! Will designate a mechanical or nonelectrical alert which could
potentially cause personal injury or death.
WARNING! Will designate electrical alerts which could potentially cause
personal injury or death.
CAUTION! Will designate an alert which could potentially cause product
damage.
Will designate grounding alerts.
SAFETY NOTICE TO USERS OF THIS MANUAL
This manual has been written and published by the Service Department of Brunswick Bowling
Products to aid the reader when servicing or installing the products described.
It is assumed that these personnel are familiar with, and have been trained in, the servicing or
installation procedures of these products, which includes the use of common mechanic’s hand tools and
any special Brunswick or recommended tools from other suppliers.
We could not possibly know of and advise the reader of all conceivable procedures by which a service
might be performed and of the possible hazards and/or results of each method. We have not attempted
any such wide evaluation. Therefore, anyone who uses a service procedure and/or tool, which is not
recommended by Brunswick, must rst completely satisfy himself that neither his nor the product’s
safety will be endangered by the service procedure selected.
All information, illustrations and specications contained in this manual are based on the latest product
information available at the time of publication.
It should be kept in mind, while working on the product, that the electrical system is capable of violent
and damaging short circuits or severe electrical shocks. When performing any work where electrical
terminals could possibly be grounded or touched by the mechanic, the power to the product should be
disconnected prior to servicing and remain disconnected until servicing is complete.