Brunswick MAX - Mode; Forward Speed; Start Cleaner

MAX Operation & Service Manual 39MAX Operation & Service Manual Section4:UnderstandingTheTabletInterface39
Mode
The mode allows you to select the type of operation you wish to perform for that pattern. You can select
between clean and oil, clean only, and oil only. The clean and oil mode cleans and condition the lanes in
one forward and reverse run. The clean only mode uses only the cleaning system, and the oil only mode
will only apply conditioner. To separate the clean and condition mode into a two-run operation refer to
“Split Pattern” later in this section.
Changing the Mode of Operation
1. Touch the Mode box with your nger.
2. Select from 3 modes of operation, Clean & Oil, Oil, or Clean.
Forward Speed
The MAX offers you three choices of travel speeds: “Fast”, “Medium” and “Slow”. In most instances
the machine will operate in the “Medium” speed (~24 inches per second). The “Fast” speed (~27
inches per second) will reduce the cleaning time and battery drain for centers using lighter volumes of
conditioner. The “Slow” speed (~21 inches per second) will increase the cleaning time and battery drain
for centers using heavier volumes of conditioner.
Changing the Forward Speed
1. Touch the Forward Speed box with your nger.
2. Select from 3 speeds Fast, Medium, or Slow based on the volume of your oil pattern.
NOTE:Thetravelspeediscriticalforcleaningperformance.Forwardspeedsettingshould
beselectedbasedontheoilpatternvolumeandthetypeoflaneoilbeingused.Forvolumes
of21mlorlessuse“Fast”.Formediumvolumepatternsof21-25mluse“Medium”.Forhigh
volumepatternsof25mlorgreateruse“Slow”.Oilthataremoredifculttocleanshoulduse
“Medium”and“Slow”.
Start Cleaner
This option allows you to set a distance down the lane, in feet, to start spraying cleaner. It is designed
for use on patterns that require the back end of the lane to be cleaned without cleaning the entire
lane. We also recommend using this option if you have wood lanes and the head (maple) section has
feathering (splintering between boards) or board separation. Software prevents your start cleaner spray
distance from being shorter than the start squeegee distance.
NOTE: Defaultsettingis0.Selectanydistanceupto57feet.Thenumbermustbelessthanor
equaltothe“StartCleanerSpray”distance.