Brunswick MAX - Start Squeegee; Start Oiling; Split Pattern; Last Update

40 MAX Operation & Service Manual40 Section4:UnderstandingTheTabletInterface MAX Operation & Service Manual
Start Squeegee
The start squeegee option is the counter part to the start cleaner spray option when used for cleaning
the back end of the lane. It also allows you to “dry” squeegee the conditioner from old wood lanes
showing feathering or board separation leaving a thin lm of oil that will help protect the wood surface.
Measured in feet, this option may be turned on before the cleaner spray starts, but not afterward.
Changing the Distance from the Foul Line at which the Squeegee Lowers
1. With your nger, swipe the Start Squeegee wheel, up and down, until you reach the desired
distance to lower the squeegee.
Start Oiling
This option is used as a safety feature on the lane machine. Select a start distance from the foul line to
start conditioning, in 6 inch increments up to 24 inches. This prevents any applying or bufng of oil
within that distance from the foul line, leaving it clean so recreational bowlers have less tendency to
track oil onto the approaches. A level 2 security ID will allow you to set the minimum distance in the
System Settings menu.
Changing the Distance from the Foul Line at which the Oiling Begins
1. With your nger, swipe the Start Oiling wheel, up and down, until you reach the desired
distance to begin the oiling.
NOTE:Defaultsettingis6inches.Selectbetween12,18,and24inches.
Split Pattern
The split pattern option enables the user to separate the “clean & oil” mode into two separate runs of
the machine performed on the same lane. By selecting “Yes” the machine will travel down the lane
performing the cleaning operation and return to the foul line. Then by the user’s action, the machine
will travel down the lane performing the conditioning operation and also bufng the pattern on the
reverse. When “No” is selected the machine will clean and condition the lanes in one operation.
Splitting the Pattern to Separate the Cleaning and Conditioning Functions
1. With your nger, touch the Split Pattern switch to change from OFF to ON.
Last Update
The last update is a feature that allows you to see if and when a conditioning pattern was last modied.
This proves helpful when trying to troubleshoot the pattern or if the pattern was suspect to an
unauthorized modication. The “Pattern change log” stores each time the pattern or its parameters are
modied.