Brunswick MAX - Section 5: Operating the Machine; Before You Start and Start-Up Procedure

MAX Operation & Service Manual 85MAX Operation & Service Manual Section 5: Operating The Machine 85
Section 5: Operating the Machine
Ready to get to work? Here’s what you need to know to start, stop, and run the machine for normal,
daily use. If you want detailed information about the sequence of operations, or to nd out more about
what’s happening within the machine at each stage, see Sequence of Operations portion of Section 7:
Troubleshooting.
In this section you will nd:
1. What to know before you get started
2. Start-up procedure
3. Shutdown procedure
4. Storing the machine
BEFORE YOU START
Step 1: Check tanks and duster cloth supply roll to be sure the machine is ready to operate.
a. Make sure cleaner and conditioner supply tanks are properly lled and caps are properly
tightened.
b. Make sure that the air was purged from the conditioner system if the conditioner system was
completely empty. Refer to Section 6 - Maintaining the Max.
c. Make sure the waste recovery tank is empty.
d. Make sure there is enough cloth on the duster cloth supply roll to complete the number of lanes
desired.
CAUTION! Fill and empty tanks with the machine in operating position (See
“Finding Your Way Around the MAX”) and away from lanes and approaches.
 Usetheno-spillcontainerandtheoilllnozzletoavoidspilling.Cleanall
spills and drips immediately.
Step 2: Position the machine on the approach.
a. With the machine in operating position, roll the machine to the rst lane, about 2 feet away
from the foul line.
b. Align the target on the top cover of the machine with the center board of the lane.