90 MAX Operation & Service Manual90 Section 5: Operating The Machine MAX Operation & Service Manual
SHUTTING DOWN
Step 1. Pull machine off of the lane and onto approach.
CAUTION! Never raise the machine into transport position until you have
emptied the waste recovery tank.
WARNING! When using the AC power cord, always disconnect it from the back
of the machine before placing the machine in transport position.
Step 2. Empty the waste recovery tank. This will allow time for the machine to depressurize the
conditioning system.
Step 3. CORDED: Turn power off at the main switch then remove the power cord from the machine.
Unplug the power cord at the power receptacle. This will shut down the Tablet and the
electrical enclosure.
BATTERY: Connect to the battery charger as soon as possible. When using the Lithium
battery, DO NOT SHUT DOWN THE MACHINE POWER. Even though the machine will
charge with the power off, you will lose the ability to track the charging in the Battery Charge
log le.
STORING THE MACHINE
1. Fill the lane cleaner and conditioner tanks before storing.
2. Stand machine upright onto its transport casters.
WARNING! Brunswick recommends using a partner whenever possible to
help with lifting or lowering the machine from the operating position. Take care
when lowering this machine into the operating position. Use proper lifting and
lowering techniques, bend at the knees, and use a back support, if needed.
3. Wrap power cord in large loops for storage, DO NOT store on lane machine.
4. Perform all daily maintenance task. Refer to Section 6: Maintaining the Max for more
information.
5. Store the machine on a secure, warm location.
6. Connect the charger to the lane machine, then turn the charger “On”.
NOTE:Thewarningbuzzerwillsoundifthechargerisnotturnedon.Refertothe
troubleshootingsection.
NOTE:Ifthebatteryoperatedmachinecannotbeconnectedtothechargerduringstorage,then
fullychargethebatteryandturnoffthemachinepowerbeforestorage.
To Next Page
Loading...
