172 MAX Operation & Service Manual172 Section7:Troubleshooting MAX Operation & Service Manual
List of Error Messages
Tables 7-1 through 7-13 provide a list of error messages with potential problems and remedies. If using
the MAX’s Diagnostics menu does not resolve your problem, please contact your Brunswick Distributor
or Brunswick Technical Support (BTS) in the United States at 1-800-YES-BOWL, or internationally at
231-725-4966. For non emergency support, e-mail techsupport@brunswickbowling.com
Error Messages that Appear During Preparation (on approach)
Error Message - Table 7-1:
The lane machine is not ready for operation.
The duster cloth is not working properly. The Duster Cloth down sensor did not activate.
Error Message - Table 7-2:
The lane machine is not ready for operation.
The squeegee is not working properly. The squeegee down sensor did not activate.
Error Message - Table 7-3:
The lane machine is not ready for operation.
The oil pressure is not set properly. The oil pressure is too low.
Error Message - Table 7-4:
The lane machine is not ready for operation.
The oil pressure is not set properly. The oil pressure is too high.
Error Message - Table 7-5:
A communication error occurred.
Error Messages that Appear During Operation (on lane)
Error Message - Table 7-6:
An error occurred during operation.
The Encoder Sensor is not working properly. The machine is not moving.
Error Message - Table 7-7:
An error occurred during operation.
The Cord Kill Switch is not working properly. The Cord Kill Switch was activated.
Error Message - Table 7-8:
An error occurred during operation.
The Buffer Brush is not working properly. The Buffer Brush down sensor was not activated.
Error Message - Table 7-9:
An error occurred during operation.
The Buffer Brush is not working properly. The Buffer Brush up sensor did not activate.
Error Message - Table 7-10:
An error occurred during operation.
The Squeegee is not working properly. The Squeegee Up sensor did not activate.
Error Messages - Table 6-11:
An error occurred during operation.
The Duster cloth is not working properly. The Duster cloth up sensor did not activate.
Error Message - Table 7-12:
An error occurred during operation.
The End of Lane Sensor is not working properly.
Error Message - Table 7-13:
Other error messages.
To Next Page
Loading...
