Brunswick MAX - Page 145

MAX Operation & Service Manual 145MAX Operation & Service Manual Section 6: Maintenance & Service 145
8. Tighten the 4 bolts on the bottom side of the center compartment to align the chain.
9. Loosen the 2 set screws on the drive shaft sprocket with a 5/32” allen wrench.
10. Carefully, tap the sprocket with a soft-face hammer to align with the motor sprocket.
NOTE: Improperalignmentwillcausedrivesystemtomakenoiseduringtravel.
11. Tighten the set screws with the 5/32” allen wrench.
Lubricating the Traction Drive Chain and Dispersion Roller Chain
Refer to Figure6-26.
1. Apply a small amount of chain grease to the traction drive chain at the sprocket and spread the
grease across the chain links.
2. Repeat the procedure for the dispersion roller chain.
Lubricating the Bearing Blocks
Refer to Figure6-26.
1. Apply one drop of oil to each side of the rear-wheel bearing blocks where the shaft and bearing
meet.
2. Repeat the procedure for the traction drive bearing blocks.