Brunswick MAX - Page 152

152 MAX Operation & Service Manual152 Section7:Troubleshooting MAX Operation & Service Manual
Normal Clean and Condition Operation on Lane
1. As the MAX is placed on the lane, the system sprays a 5 second pulse of cleaner as the duster
contact roller assembly is lifted off the “down” switch (only if the start cleaner distance and the
start squeegee distance are set at “0” in the Pattern Parameters Screen).
2. Once the machine is properly seated on the lane with the rear wheels aligned with the gutters
just in front of the foul line, and the operator presses the handle button for the second time, the
control system:
a. Turns on the traction drive motor to accelerate the machine toward the pin deck.
b. Directs the cleaner pump to apply a steady spray of cleaning uid on the lane.
c. Vacuums the used conditioner and cleaner (if using AC power otherwise the vacuum will
start at the operator selected distance in the System Machine Setting screen).
d. Lowers the buffer brush into contact with the lane surface via the buffer lifting motor at a
distance specied by the operator.
e. Turns on the buffer drive motor to start rotating the buffer brush and turns on the
dispersion motor to start rotating the dispersion roller.
f. Tells the conditioning system to inject conditioner onto the lane surface according to the
user’s selected pattern.
3. The machine continues at a steady forward speed and the control system:
a. Stops the buffer drive and dispersion motors and raises the buffer brush at the end of the
user specied conditioner pattern.
b. Turns off the cleaner spray at the user specied distance.
c. Pulses the cleaner spray on and off before the pin deck.
d. Stops the machine at the end of the lane after the end of lane sensor is activated.
e. Winds the duster cloth to the up position, and advances more cloth for use on the next lane.