Brunswick MAX - Page 24

24 MAX Operation & Service Manual24 Section3:MAXPowerSystem MAX Operation & Service Manual
The MAX machine should now be powered by the 24VDC nominal output of the AC/DC Power
Supply and operate similarly as if it were powered by a battery. The blue LED indicator will illuminate
indicating the machine is operating on AC power. The operator will now need to manage the power
cord so that it does not get trapped under the lane machine during operation.
The 125’ power cord should only be connected to the AC/DC Twist-Lock connector on the rear cover
when the MAX is in the operating position. This cord should be disconnected before the machine is
lifted into the transport position. If the batteries are not fully charged, the AC/DC Power Supply cable
should be disconnected from the electrical enclosure after running the lanes and the battery power cable
should be reconnected to the electrical enclosure.
NOTE: Remember,alwaysconnectthebatterychargertoMAXlanemachinewhennotrunning
lanes.