Brunswick MAX - Page 36

36 MAX Operation & Service Manual36 Section4:UnderstandingTheTabletInterface MAX Operation & Service Manual
Setting up a Lane Maintenance Schedule that may Vary by Day, Time, or Lane Ranges
1. Turn on the Pattern Scheduler by touching the ON/OFF switch on the screen.
2. Select the Day of the week.
a. Touch the “Day of the Week” button.
b. Touch the day you wish to schedule on the screen.
3. Select the time period you wish to set (up to 3 periods per day).
a. To use the same pattern for the entire day, use the following settings.
i. Select time period “1” by touching the screen.
ii. Set the “Start Time” to “00:00” by swiping the wheel up or down with your nger.
iii. Set the “End Time” to “23:59” by swiping the wheel up or down with your nger.
b. To use different patterns during different times of the day, enter start and end times until
the remaining time periods equal a 24 hour day.
4. Selecting the lane ranges and pattern.
a. To use the same pattern on all lanes, use the default setting:
i. Start lane is “1”.
ii. End lane is “40” (end lane is the number of lanes in your center).
b. To select a pattern, swipe the pattern wheel up or down until you have your desired pattern.
c. To create 2 lane ranges, use the following settings example:
i. Start lane is “1”.
ii. End lane is “20”.
iii. Select the desired pattern for this lane range.
iv. Start lane is “21”.
v. End lane is “40”
vi. Select the desired pattern for this lane range.
NOTE:Ifanydayortimeperiodisleftwithoutascheduledpattern,alllaneswillrunonthe
defaultpattern(pattern1).Pleasechecktomakesurethatyouhavenotallowedtimegaps
betweenanyofthe3allowabletimeperiodsorlaneranges.Thesegapscouldresultinan
unexpectedpatternselectionifthelanemachineisinoperationduringthattimegap.
5. Leave the Pattern Menu to save changes.