Brunswick MAX - Page 42

42 MAX Operation & Service Manual42 Section4:UnderstandingTheTabletInterface MAX Operation & Service Manual
Modifying a Zone
1. Select a zone you wish to modify using your nger.
2. Use the Up or Down arrow to change the length of an individual zone
NOTE:TheTabletwillpromptyoutodownloadthepatterntothemachinecontrolboardafter
youexitthezonecongurationscreen.Press“OK”tostartthedownloador“Exit”todownload
atalatertime.
Adding a Zone
1. Press the Add Zone button and a new zone will appear at the end of the oil pattern.
2. Modify the new zone to the length and prole you wish.
Remove Zone
1. Select the zone you want to remove so it is highlighted.
2. Press Remove Zone and that zone will be removed from the pattern.
NOTE:Itmaybenecessarydoadjustthelengthsofotherzoneswhenaddingorremoving,to
achievethedesiredoverallpatternlength.
Changing the End Cleaner Spray Distance
The cleaner is applied in a continuous spray to the lane during the cleaning operation. You can select
the distance at which the cleaner spray ends between 45’ and 57’. This lets you synchronize the cleaner
usage with each patterns cleaning needs. The cleaner can be turned off earlier, allowing the surplus
cleaner in the scrubbing vacuum head assembly to clean the back ends of the lane. The MAX will
always spray the pin deck with cleaner.
1. Use the up or down arrows to adjust the End Cleaner Spray distance. You may also touch and
drag the image to increase or decrease the End Cleaner distance.
Viewing the Oil Levels of a Zone
1. Touch the zone you wish to modify or view.
2. Touch the same zone again to enter into the Oil Levels screen.