Brunswick MAX - Page 61

MAX Operation & Service Manual 61MAX Operation & Service Manual Section4:UnderstandingTheTabletInterface61
Changing the Vacuum ON and OFF Distances
1. Go to the System menu and select Machine Settings.
2. Changing the Going Forward, Start Vacuum At.
a. Swipe the scroll wheel up or down to the selected distance you would like the vacuum to
begin. It is recommended not to go further than 30 feet.
3. Changing the Returning, Stop Vacuum At.
a. Swipe the scroll wheel to the selected distance you would like the vacuum to begin.
4. Exit to another menu to save changes.
NOTE:ChangingthedistancewherethevacuumturnsONandOFFallowsyoutoconserve
batterypowerandhelpsmaintainahealthybattery.ItisnotrecommendedtoturnONthe
vacuumbeyond30feettopreventcleanerfrombeingpushedintotheguttersandtoensurethat
allofthewasteispulledintothewastetank.TurningthevacuumOFFonthereturnwillalso
helpconservebatterypowerbutcancausedirtycleanerdripsasthemachinereturnstothefoul
line.
Changing the Squeegee Wipe Delay
1. Go to the System menu and select Machine Settings.
2. Swipe the scroll wheel up or down to select the amount of time (tenths of seconds) until the
squeegee is wiping the back of the pin deck as the machine begins its return to the foul line.
3. Exit to another menu to save your changes.
NOTE:TheSqueegeeWipeDelayisusedtoreleaseexcessmoisturefromthesqueegeeblade
topreventdirtycleanerdripsasthemachinereturns.Itisimportanttosetthisoptionsothatthe
centerofthesqueegeewipesnomorethan2inchesontothepindeck.Thissettingissetbyyour
machineinstaller.
Changing the End Of Lane Speed Adjustment
1. Go to the System menu and select Machine Settings.
2. Swipe the scroll wheel up or down to select the value.
a. If the value is increased, the drive motor voltage will increase to ensure that the machine
travels to the end of the pin deck.
b. If the value is decreased, the drive motor voltage will decrease slightly to ensure that the
machine does not travel beyond the end of the pin deck.
3. Exit to another menu to save your changes.
Changing the Base Voltage Adjustment
1. Go to the System menu and select Machine Settings.
2. Swipe the scroll wheel up or down to select the value.
a. If the value is increased (0.5 increments), the machine speed will increase and the machine
will complete its run in a faster time.
b. If the value is decreased (0.5 increments) the machine speed will decrease and the machine
will complete its run in a slower time.
3. Exit to another menu to save your changes.
NOTE:ConsultBrunswickTechnicalSupportforchangingthissettingasotheradjustments
maycausethemachinetotravelslower.