Brunswick MAX - Machine Operation Steps

MAX Operation & Service Manual 87MAX Operation & Service Manual Section 5: Operating The Machine 87
Step 2: Press handle button or “Prepare for Lane #” to prepare the machine to run.
NOTE: Duringrstusageyouarerequiredtodownloadapatternifyouchangethepatternor
changetheselectedconditioner.
a. The machine lowers the duster contact roller and squeegee into operating position, turns
on the vacuum motor (AC power only) and pressurizes the conditioning system.
NOTE:Aftertherstlane,machinewillpressurizetheconditioningsystemwhenthereverse
passiscompleted.
b. The display screen displays “Put the lane machine on the lane” when the machine is ready to
begin operation.
c. Position the machine on the lane with the rear caster wheels aligned with the gutter just in front
of the foul line. Use the handle magnetic catch to center the machine onto the lane.
d. When putting the machine on the lane, once the duster cloth contacts the lane surface, the
machine will pulse spray cleaner for 5 seconds.
Step 3: Press handle button a second time to begin operation on rst lane.
a. The machine accelerates forward, automatically cleaning and conditioning the lane until
it reaches the pin deck. Foradetaileddescriptionoftheseoperations,refertoSection7,
Troubleshooting,SequenceofOperations.
b. When the machine reaches the end of the pin deck, it reverses direction and returns to the foul
line, completing the conditioning operation.
c. The Tablet displays the number of the next lane to be cleaned and conditioned.
CAUTION! When using the AC power cord, manage the power cord so it does
not get trapped under the lane machine. Replace the protective sleeve and
heat shrink tubing on the power cord if they become damaged.
Step 4: Move machine to subsequent lanes.
a. When the lane is completed, pull the machine back onto the approach about 3 feet from the foul
line.
b. Turn machine and use the rear lane to lane wheels to steer it to the next lane. Press “OK” to
prepare the machine to run and wait for the display screen to prompt “Put the lane machine on
the lane.”
c. Position the larger front wheels so they align with the gutter just in front of the foul line of the
next lane.
d. Press “OK” to begin operation on the lane.
e. Continue same procedure on subsequent lanes.