MAX Operation & Service Manual 93MAX Operation & Service Manual Section 6: Maintenance & Service 93
1. Empty waste recovery tank, after each use, and wipe with a dry cloth.
CAUTION! You must empty the waste recovery tank before transporting
machine.
2. Wipe frame division wall.
3. Check duster cloth supply roll and replace if needed.
4. Fill cleaner supply tank.
a. Remove cap from cleaning tank, remove cap on end of the ll tube, located on the cleaner
mixing vessel, and insert ll tube into cleaning tank.
CAUTION!UseonlyBrunswickapprovedcleaninguids.
b. Press and hold button on container until cleaner nears the bottom of the tank neck. Do not
ll into the neck of the tank.
c. Release button and let cleaner remaining in tube drain into tank before replacing the cap
on the end of the ll tube.
d. Wipe any drips that collect in the depressed area around the outside of the tank neck.
WARNING! Fill and empty tanks with the machine in operating position and
away from lanes and approaches. Use the no-spill containers to avoid spilling.
Clean all spills and drips immediately.
5. Fill conditioner supply tank.
NOTE:Thellspoutinthesparepartskitshouldtontotheconditionercontainer.
a. Remove cap from conditioner tank, cap on end of the ll spout and insert ll tube into
conditioner tank.
CAUTION!UseonlyBrunswickapprovedconditioneruids.
b. Slowly tilt the oil container until conditioner begins to ow and continue until the oil nears
the bottom of the tank neck. Do not ll into the neck of the tank.
c. Let any conditioner remaining in tube drain into tank before replacing the cap on the end
of the ll tube.
d. Wipe any drips that collect in the depressed area around the outside of the tank neck.
Remove the neck foam and squeeze with a dry towel if it becomes saturated with oil..
6. Wipe conditioning compartment, including any areas that shows oil residue, with a dry cloth.
WARNING! Take care when working around electrical connections to avoid
damaging wire connections.
7. Wipe top, rear and side covers.
To Next Page
Loading...
