MAX Operation & Service Manual 95MAX Operation & Service Manual Section 6: Maintenance & Service 95
6. Wipe bottom side of machine, including traction drive, rear wheels, rear guide wheels, rear
shaft, and rear frame area.
7. Blot injector tips with a lint-free terry cloth.
8. Remove the foam strip from the lower edge of the buffer shield. Squeeze the conditioner from
the foam strip by placing it between layers of a terry cloth towel and applying pressure. Do not
twist or wring out the foam strip to avoid stretching or tearing it.
9. Wipe the inside surface of the buffer brush shield with a terry cloth towel.
10. Replace the dry foam strip over the retaining pins on the buffer shield. Make sure that the foam
strip is pushed completely onto the base of the retaining pins so there is no gap between the
surface of the buffer shield and the foam strip.
11. Replace the buffer shield foam strip with a replacement in the spare parts kit or order a new
foam strip (reorder part number 14-100427-000) if it becomes torn, stretched or does not remain
tightly attached to the buffer brush shield.
12. Begin the battery charging cycle.
a. Plug the battery charger into the charging port on the 7-pin side of the machine covers.
b. Verify the green power light is on – if not check the E-stop and power switches to verify
they are not off.
c. Plug in and turn on the battery charger.
d. Verify the charge output voltage and current display correctly.
WARNING! Always inspect approach areas and clean spills or drips
immediately. Replace any loose foam.
NOTE:TheDailyMaintenanceDecalonthebottomofthemachine(refertoFigure6-2)
containshelpfulremindersforeachstepexplainedabove.
To Next Page
Loading...
