EasyManua.ls Logo

Case SDX30 - Safety During Transport; Safety Decals

Case SDX30
171 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 1 - SAFETY
page 1-10
SAFETY DURING TRANSPORT
CHECK
with local authorities regarding transport on
public roads. Obey all applicable laws and regulations.
ONLY TOW
at a safe speed [32 km/hr (20 mph)]. Use
caution when turning corners or meeting traffic.
BE SURE
safety lighting is plugged in and that the red
taillight(s), amber flashers, and amber signal lights are all
working properly.
ALWAYS
be certain that no one is behind or near the drill
before moving it.
BE SURE
all safety transport locks are in place before
transporting the drill.
BE SURE
the reflector decals are clearly visible from all
sides of the drill and the ‘Slow Moving Vehicle’ sign is at
the rear of the drill in clear view of overtaking traffic.
BE SURE
the tractor weight is equal to or greater than the
total weight of the air cart and drill.
BE SURE
all the wheel bolts are torqued to proper
specifications before transporting the drill.
WATCH
for power poles and overhead power lines.
ALWAYS
lock the tractor drawbar when transporting the
drill.
ALWAYS
park the drill on level ground and block the
wheels before unhooking from the towing vehicle.
NEVER
subject the drill to steep side grades while in
transport position.
ALWAYS
use the hitch jack supplied with the drill when
unhooking from the tractor.
NEVER
brake or decelerate during cornering.
ALWAYS
enter corners slowly. SLOW the machine to
turning speed before entering a corner.
DO NOT
decelerate while executing the turn.
SAFETY DECALS
KEEP SAFETY DECALS CLEAN
. Wipe clean when
necessary.
CHECK
that the safety decals are not obstructed by the
openers. If the decals are covered up, replace in a location
that is clear to view.
REPLACE
missing or unreadable decals. New decals are
available from your dealer.
To replace decals:
1. Remove the old decal. Clean the area where the new
decal will be affixed.
2. Remove the decal backing. Carefully affix the decal to
the drill.
3. Work the air bubbles out from under the decal. Use a
clean piece of paper or the decal backing itself.

Table of Contents

Related product manuals