SECTION 4 - ELECTRICAL SYSTEM SERVICE
page 4-3
ELECTRICAL SYSTEM SERVICE
TURN SIGNAL AND FLASHER LAMP BULBS
1. Remove the screws.
2. Push down and rotate counterclockwise to remove
bulb.
3. Install the new bulb.
4. Install the cover and screws.
TAIL LAMP
1. Remove the tail lamp and mounting plate from the
frame.
2. Rotate the base 90
/ counterclockwise and pull to
remove the holder and bulb.
3. Pull the bulb from the holder.
4. Install the new bulb.
5. Push and rotate clockwise to install the bulb holder.
To Next Page
Loading...
