Case SDX30 - Index

INDEX
ADX Air System ....................... 6-17
Header Assemblies .................. 6-17
Air System............................. 6-9
Balancing the Air Flow................. 6-9
Theory of Operation .................. 6-9
Bogie Hub and Spindle .................. 2-27
Bolt Torque ............................ 2-4
Caster Assembly....................... 2-27
SDX30 ............................ 2-28
SDX40 ....................... 2-30, 2-32
Center Section
SDX30 ............................ 2-18
SDX40 ............................ 2-23
Concord Air Systems ................... 6-12
Front Tow Primary Manifold Stand ...... 6-12
Pivot Assembly Manifold Stands ........ 6-14
Primary Manifold ................... 6-15
Rear Tow Primary Manifold Stands ..... 6-13
Secondary Manifold ................. 6-16
Setting the Fan Speed ................. 6-7
Connector Service ..................... 4-10
Contact Replacement ................ 4-10
Cylinder Components ................... 3-12
SDX30 Subbar ...................... 3-12
SDX30 Wing Lift .................... 3-14
SDX40 Subbar ...................... 3-13
SDX40 Wing Lift .................... 3-16
Cylinder Seal Replacement ............... 3-3
Decal Locations ....................... 1-11
SDX30 Safety Decal Locations......... 1-11
SDX40 Safety Decal Locations......... 1-12
Dimensions ............................ 2-6
Down Pressure ........................ 5-5
Spring Position ...................... 5-6
Endmarkers............................ 7-3
Bearing Replacement ................ 7-16
Safety.............................. 7-3
Service............................ 7-16
Frame Brace Kit ....................... 2-13
SDX30 ............................ 2-14
General Maintenance .................... 2-8
Grease Locations ....................... 2-8
Hoses ................................ 6-8
Hydraulic Schematics ................... 3-19
SDX30 Subbar, 2
nd
Serial Range ....... 3-24
SDX30 Subbar, 1
st
Serial Range ....... 3-26
SDX30 Wing Lift, 2
nd
Serial Range ...... 3-19
SDX30 Wing Lift, 1
s
t Serial Range ...... 3-20
SDX40 Subbar ..................... 3-30
SDX40 Wing Lift .................... 3-22
Locking Openers / Subbar for Service ....... 2-6
Subbar Cylinder Lock ................. 2-6
Open Hose Method ..................... 6-10
Openers
Down Pressure ...................... 5-5
Gauge Wheel ....................... 5-8
Scraper ............................ 5-7
Seed Firming Wheel ................. 5-10
Seed Retention Tab ................. 5-10
Opener Service ........................ 5-11
Gauge Wheel Assembly .............. 5-11
Main Cast Arm Bushings.............. 5-17
Packer Wheel Assembly .............. 5-13
Repair the Seed Tube ................ 5-16
Scraper Assembly ................... 5-15
Seed Firming Wheel ................. 5-14