SECTION 2 - MECHANICAL SERVICE
page 2-7
REPLACING SERIAL/PIN PLATE
In cases where the frame member that the Identification
Plate is attached to is damaged and the owner wishes to
replace that part of the frame, the replacement part will
not have a pin plate on it because it is a replacement part
and not part of the machine as shipped.
If the plate is able to be moved from the existing location
to the new part, carefully remove the rivets and attach to
the new frame part using the two drive screws.
To order a replacement identification plate call Corporate
Security. A replacement will be delivered.
To Next Page
Loading...
