SECTION 7 - ENDMARKER SERVICE
page 7-7
Endmarker Adjustments
202257M1
Offset Pin at Knuckle Pivot
202258M1
ADJUSTMENTS
1. Endmarker adjustments.
- Bifold pivot (1).
- Knuckle pivot (4).
- For correct adjustment of the endmarker the
primary arm (3) needs to be parallel to the toolbar.
The secondary arm (2) needs to be parallel to the
primary arm (3).
2. Offset pin at knuckle pivot.
- Adjust the offset pin at the knuckle pivot to align
the endmarker making it parallel to the toolbar.
- Loosen the 5/8" bolt (1).
- Turn the offset pivot pin (2) on the head until the
endmarker is aligned..
To Next Page
Loading...
