SECTION 3 - HYDRAULIC SYSTEM SERVICE
page 3-4
Loosening Clevis Set Screw
202036M1
Removing the Clevis
202039M1
Removing Connector Rods
202041M1
7. Remove the clevis end (1) by loosening the set screw.
8. Use a rod (1) inserted in the clevis (2) to unscrew the
clevis end off of the shaft.
9. Reposition the cylinder (1) so the vise (2) is clamping
on the body of the cylinder. Wooden blocks (3) or
other suitable material should be used to protect the
cylinder body from damage.
NOTE: Cylinder damage can occur. Do not over-
tighten the vise on the cylinder barrel.
10. Remove the tie rods that connect the clevis cap and the
end cap onto the cylinder. Remove the nut from one
end only, and then slide the rods out of the caps.
To Next Page
Loading...
