Cisco ASR 9000 Series - Page 10

Configuring Static Pseudowires at T-PE1 Node: Example 188
Configuring Static Pseudowires at S-PE1 Node: Example 188
Configuring Static Pseudowires at T-PE2 Node: Example 188
Preferred Path: Example 188
MPLS Transport Profile: Example 189
Configuring Preferred Tunnel Path: Example 189
Configuring PW Status OAM: Example 189
Viewing Pseudowire Status: Example 189
show l2vpn xconnect 189
show l2vpn xconnect detail 189
Configuring Any Transport over MPLS: Example 190
Configuring AToM IP Interworking: Example 191
Configuring PPP IP Interworking: Example 191
Configuring cHDLC IP Interworking: Example 191
Configuring MLPPP IP Interworking: Example 192
Configuring Circuit Emulation Over Packet Switched Network: Example 192
Configuring L2VPN Nonstop Routing: Example 193
Enabling Pseudowire Grouping: Example 194
Configuring L2TPv3 over IPv6 Tunnels: Example 194
Configuring Neighbor AFI for Pseudowire: Example 194
Configuring L2TPv3 encapsulation and protocol: Example 194
Configuring Source IPv6 address for L2TPv3 over IPv6 tunnel: Example 194
Configuring Local and Remote Sessions: Example 194
Configuring Local and Remote Cookies: Example 195
Enabling L2TP Static Submode: Example 195
Enabling TOS Reflection in the L2TPv3 Header: Example 196
Configuring TTL for L2TPv3 over IPv6 Tunnels: Example 196
Configuring Traffic Mirroring over L2TPv3 over IPv6 Tunnels: Example 196
Configuring L2TPv3 over IPv4 Tunnels: Example 197
Configuring a Dynamic L2TPv3 Pseudowire 197
Configuring L2TPv3 Encapsulation and Protocol: Example 198
Configuring L2TP Control-Channel Parameters: Example 199
Configuration Examples for EVPN-VPWS 199
Configuring EVPN-VPWS: Example 199
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
x
Contents