Cisco ASR 9000 Series

• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring VPN ID
Perform this task to configure a VPN ID.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain bridge-domain-name
5. vfi { vfi-name }
6. vpn-id vpn-id
7. autodiscovery bgp
8. rd { as-number:nn | ip-address:nn | auto }
9. route-target export { as-number:nn | ip-address:nn }
10. signaling-protocol bgp
11. ve-id { number }
12. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group bridge-group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group metroA
Enters Layer 2 VPN VPLS bridge group configuration mode.
Step 4 bridge-domain bridge-domain-name
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
317
Implementing Multipoint Layer 2 Services
Configuring VPN ID