Cisco ASR 9000 Series Configuration Guidelines

Configuring L2VPN Quality of Service
This section describes how to configure L2VPN quality of service (QoS) in port mode and mode, VLAN
mode, Frame Relay and ATM sub-interfaces.
Restrictions
The l2transport command cannot be used with any IP address, L3, or CDP configuration.
Configuring an L2VPN Quality of Service Policy in Port Mode
This procedure describes how to configure an L2VPN QoS policy in port mode.
In port mode, the interface name format does not include a subinterface number; for example,
GigabitEthernet0/1/0/1.
Note
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. l2transport
4. service-policy [ input | output ] [ policy-map-name ]
5. Use the commit or end command.
6. show qos interface type interface-id service-policy [ input | output ] [ policy-map-name ]
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the configuration mode.
Step 2 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/0/0/0
Specifies the interface attachment circuit.
Step 3 l2transport
Example:
RP/0/RSP0/CPU0:router(config-if)# l2transport
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
109
Implementing Point to Point Layer 2 Services
Configuring L2VPN Quality of Service

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model