Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

RP/0/RSP0/CPU0:router(config)# l2vpn

RP/0/RSP0/CPU0:router(config-l2vpn)#

Enters L2VPN configuration mode.

Step 3 xconnect group group-name

Example:

RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group A

RP/0/RSP0/CPU0:router(config-l2vpn-xc)#

Enters the name of the cross-connect group.

Step 4 p2p xconnect-name

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p rtrX_to_rtrY

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)#

Enters a name for the point-to-point cross-connect.

Step 5 neighbor ip-address pw-id value

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 1.1.1.1 pw-id 2

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)#

Configures the pseudowire segment for the cross-connect.

Step 6 neighbor { A.B.C.D } { pw-id value }

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 10.1.1.2 pw-id 11

Configures the backup pseudowire for the cross-connect.

Step 7 Use the commit or end command.

commit - Saves the configuration changes and remains within the configuration session.

end - Prompts user to take one of these actions:

• Yes - Saves configuration changes and exits the configuration session.

• No - Exits the configuration session without committing the configuration changes.

• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring Point-to-Point Pseudowire Redundancy

Perform this task to configure point-to-point pseudowire redundancy for a backup delay.

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

122

Implementing Point to Point Layer 2 Services

Configuring Point-to-Point Pseudowire Redundancy

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series