Cisco ASR 9000 Series Configuration Guidelines

CHAPTER 1
New and Changed VPN Features
This table summarizes the new and changed feature information for the L2VPN and Ethernet Services
Configuration Guide for Cisco ASR 9000 Series Routers, and tells you where they are documented.
• New and Changed VPN Features, on page 1
New and Changed VPN Features
Table 1: VPN Features Added or Modified in IOS XR Release 6.3.x
Where DocumentedChanged in ReleaseDescriptionFeature
EVPN Anycast Gateway
All-Active Static
Pseudowire, on page 547
Release 6.3.1The EVPN Anycast
Gateway All-active Static
Pseudowire (PW) feature
enables all-active
multi-homing support for
static PWs. When static
PWs are configured, it
overrides the default
behavior of single-active,
and the node becomes
all-active per flow
(AApF).
EVPN Anycast Gateway
All-Active Static
Pseudowire
CFM Support for EVPN,
on page 553
Release 6.3.1CFM can be deployed in
an EVPN network. You
can monitor the
connections between the
nodes using CFM in an
EVPN network.
CFM Support for EVPN
EVPN IPv6 Hosts with
Mobility, on page 601
Release 6.3.2EVPN IPv6 Hosts with
Mobility feature enables
you to provide EVPN
IPv6 service over
IPv4-MPLS core network.
EVPN IPv6 Hosts with
Mobility
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
1

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model