RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 10.2.2.2 pw-id 2000
Configures the pseudowire segment for the cross-connect.
Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix.
Note
Step 12 pw-class class-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class path1
Associates the pseudowire class with this pseudowire.
Step 13 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Enabling Load Balancing with ECMP and FAT PW for VPLS
Perform this task to enable load balancing with ECMP and FAT PW for VPLS.
SUMMARY STEPS
1. configure
2. l2vpn
3. load-balancing flow {src-dst-mac | src-dst-ip}
4. pw-class { class - name }
5. encapsulation mpls
6. load-balancing flow-label { both | code | receive | transmit } [ static ]
7. exit
8. bridge group bridge-group-name
9. bridge-domain bridge-domain-name
10. vfi { vfi-name }
11. autodiscovery bgp
12. signaling-protocol bgp
13. load-balancing flow-label { both | code | receive | transmit } [ static ]
14. Use the commit or end command.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
289
Implementing Multipoint Layer 2 Services
Enabling Load Balancing with ECMP and FAT PW for VPLS
To Next Page
Loading...
Need help?
General
