Cisco ASR 9000 Series

RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 interface type interface-path-id.subinterface l2transport
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet0/0/0/0.1 l2transport
Configures an interface or connection for L2 switching.
In VLAN Mode, you must enter the l2transport keyword on the same line as the interface.
Note
Step 3 service-policy [ input | output ] [ policy-map-name ]
Example:
RP/0/RSP0/CPU0:router(config-if)# service-policy input servpol1
Attaches a QoS policy to an input or output interface to be used as the service policy for that interface.
Step 4 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Multisegment Pseudowire
This section describes these tasks:
Provisioning a Multisegment Pseudowire Configuration
Configure a multisegment pseudowire as a point-to-point (p2p) cross-connect. For more information on P2P
cross-connects, see the “Configuring Static Point-to-Point Cross-Connects".
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group group-name
4. p2p xconnect-name
5. neighbor A.B.C.D pw-id value
6. pw-class class-name
7. exit
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
111
Implementing Point to Point Layer 2 Services
Configuring Multisegment Pseudowire