Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Configuring a Gigabit Ethernet Interface

Perform this task to configure a basic Gigabit Ethernet or 10-Gigabit Ethernet interface:

SUMMARY STEPS

1. configure

2. interface type interface-path-id

3. ipv4 address ip-address mask

4. flow-control { bidirectional | egress | ingress }

5. mtu bytes

6. mac-address value1.value2.value3

7. negotiation auto (on Gigabit Ethernet interfaces only)

8. no shutdown

9. Use the commit or end command.

10. show interfaces [ GigabitEthernet | TenGigE ] instance

DETAILED STEPS

Step 1 configure

Example:

RP/0/RSP0/CPU0:router# configure terminal

Enters the Global Configuration mode.

Step 2 interface type interface-path-id

Example:

RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/1/0/0

Enters interface configuration mode and specifies the Ethernet interface name and notation rack/slot/module/port.

Step 3 ipv4 address ip-address mask

Example:

RP/0/RSP0/CPU0:router(config-if)# ipv4 address 172.18.189.38 255.255.255.224

Assigns an IP address and subnet mask to the interface.

• Replace ip-address with the primary IPv4 address for the interface.

• Replace mask with the mask for the associated IP subnet. The network mask can be specified in either of two

ways:

• The network mask can be a four-part dotted decimal address. For example, 255.0.0.0 indicates that each bit

equal to 1 means that the corresponding address bit belongs to the network address.

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

The Carrier Ethernet Model

Configuring a Gigabit Ethernet Interface

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series