Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# address-fmaily l2vpn evpn
Configures EVPN address family.
Step 8 import stitching-rt reoriginate
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)# import stitching-rt reoriginate
Enables import of routing information from BGP EVPN NLRIs that has route target identifier matching the stitching
route target identifier and exports this routing information after re-origination to the L2VPN BGP neighbor.
Step 9 route-policy route-policy-name in
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)# route-policy pass-all in
Applies the route policy to inbound unicast routes.
Step 10 encapsulation-type type
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)# encapsulation-type vxlan
Configures VXLAN as encapsulation type.
Step 11 route-policy route-policy-name out
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)# route-policy pass-all out
Applies the route policy to outbound unicast routes.
Step 12 advertise l2vpn evpn re-originated stitching-rt
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)# advertise l2vpn evpn re-originated stitching-rt
Configures advertisement of L2VPN EVPN routes to be received from the L2VPN BGP neighbor.
Step 13 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No- Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configure BGP session for remote DCI Connectivity
Perform this task to configure BGP session for remote DCI connectivity.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
506
EVPN Features
Configure BGP session for remote DCI Connectivity
To Next Page
Loading...
Need help?
General
