Cisco ASR 9000 Series

neighbor 10.3.3.3 pw-id 1
!
!
interface loopback 0
ipv4 address 10.1.1.1 255.255.255.25
This configuration example shows how to configure PE 2:
configure
l2vpn
bridge group 1
bridge-domain PE2-VPLS-A
interface TenGigE0/0/0/1
vfi 1
neighbor 10.1.1.1 pw-id 1
neighbor 10.3.3.3 pw-id 1
!
!
interface loopback 0
ipv4 address 10.2.2.2 255.255.255.25
This configuration example shows how to configure PE 3:
configure
l2vpn
bridge group 1
bridge-domain PE3-VPLS-A
interface TenGigE0/0/0/2
vfi 1
neighbor 10.1.1.1 pw-id 1
neighbor 10.2.2.2 pw-id 1
!
!
interface loopback 0
ipv4 address 10.3.3.3 255.255.255.25
MultipointLayer 2ServicesConfigurationforProvider Edge-to-CustomerEdge:
Example
This configuration shows how to configure Multipoint Layer 2 Services for a PE-to-CE nodes:
configure
interface TenGigE0/0/0/0
l2transport---AC interface
no ipv4 address
no ipv4 directed-broadcast
negotiation auto
no cdp enable
Displaying MAC Address Withdrawal Fields: Example
This sample output shows the MAC address withdrawal fields:
RP/0/RSP0/CPU0:router# show l2vpn bridge-domain detail
Legend: pp = Partially Programmed.
Bridge group: 222, bridge-domain: 222, id: 0, state: up, ShgId: 0, MSTi: 0
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
322
Implementing Multipoint Layer 2 Services
Multipoint Layer 2 Services Configuration for Provider Edge-to-Customer Edge: Example