Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p vlan1
Enters a name for the point-to-point cross-connect.
Step 5 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface GigabitEthernet0/0/0/0.1
Specifies the interface type ID. The choices are:
• GigabitEthernet: GigabitEthernet/IEEE 802.3 interfaces.
• TenGigE: TenGigabitEthernet/IEEE 802.3 interfaces.
• CEM: Circuit Emulation interface
Step 6 neighbor A.B.C.D pw-id pseudowire-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 2.2.2.2 pw-id 2000
Configures the pseudowire segment for the cross-connect.
Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN.
Step 7 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Inter-AS
The Inter-AS configuration procedure is identical to the L2VPN cross-connect configuration tasks (see
“Configuring Static Point-to-Point Cross-Connects” section and “Configuring Dynamic Point-to-Point
Cross-Connects” section) except that the remote PE IP address used by the cross-connect configuration is
now reachable through iBGP peering.
You must be knowledgeable about IBGP, EBGP, and ASBR terminology and configurations to complete this
configuration.
Note
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
108
Implementing Point to Point Layer 2 Services
Configuring Inter-AS
To Next Page
Loading...
Need help?
General
