MPLS Transport Profile: Example
This section provides examples for:
• Configuring Preferred Tunnel Path: Example
• Configuring PW Status OAM: Example
Configuring Preferred Tunnel Path: Example
This sample configuration shows how to configure preferred tunnel path:
l2vpn
pw-class foo
encapsulation mpls
preferred-path interface tunnel-tp 100 fallback disable
commit
Configuring PW Status OAM: Example
This sample configuration shows how to configure PW status OAM functionality:
l2vpn
pw-oam refresh transmit 100
commit
Viewing Pseudowire Status: Example
show l2vpn xconnect
RP/0/RSP0/CPU0:router# show l2vpn xconnect
Legend: ST = State, UP = Up, DN = Down, AD = Admin Down, UR = Unresolved,
LU = Local Up, RU = Remote Up, CO = Connected
XConnect Segment 1 Segment 2
Group Name ST Description ST Description ST
------------------------ ------------------------- -------------------------
MS-PW1 ms-pw1 UP 70.70.70.70 100 UP 90.90.90.90 300 UP
--------------------------------------------------------------------------------
show l2vpn xconnect detail
RP/0/RSP0/CPU0:router# show l2vpn xconnect detail
Group MS-PW1, XC ms-pw1, state is up; Interworking none
PW: neighbor 70.70.70.70, PW ID 100, state is up ( established )
PW class not set
Encapsulation MPLS, protocol LDP
PW type Ethernet VLAN, control word enabled, interworking none
PW backup disable delay 0 sec
Sequencing not set
PW Status TLV in use
MPLS Local Remote
------------ ------------------------------ -----------------------------
Label 16004 16006
Group ID 0x2000400 0x2000700
Interface GigabitEthernet0/1/0/2.2 GigabitEthernet0/1/0/0.3
MTU 1500 1500
Control word enabled enabled
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
189
Implementing Point to Point Layer 2 Services
MPLS Transport Profile: Example
To Next Page
Loading...
Need help?
General
