Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi-ad-sig)# ve-id 10
Specifies the local PE identifier for the VFI for VPLS configuration.
The VE ID identifies a VFI within a VPLS service. This means that VFIs in the same VPLS service cannot share the
same VE ID. The scope of the VE ID is only within a bridge domain. Therefore, VFIs in different bridge domains
within a PE can use the same VE ID.
Step 14 ve-range { number }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi-ad-sig)# ve-range 40
Overrides the minimum size of VPLS edge (VE) blocks.
The default minimum size is 10. Any configured VE range must be higher than 10.
Step 15 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring VPLS with BGP Autodiscovery and LDP Signaling
Perform this task to configure BGP-based Autodiscovery and signaling:
SUMMARY STEPS
1. configure
2. l2vpn
3. router-id ip-address
4. bridge group bridge-group-name
5. bridge-domain bridge-domain-name
6. transport-mode vlan passthrough
7. vfi {vfi-name}
8. autodiscovery bgp
9. vpn-id vpn-id
10. rd {as-number:nn | ip-address:nn | auto}
11. route-target {as-number:nn | ip-address:nn | export | import }
12. route-target import {as-number:nn | ip-address:nn}
13. route-target export {as-number:nn | ip-address:nn}
14. signaling-protocol ldp
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
270
Implementing Multipoint Layer 2 Services
Configuring VPLS with BGP Autodiscovery and LDP Signaling
To Next Page
Loading...
Need help?
General
