Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Step 6 neighbor ipv6 peer-address pw-id pseudowire-id

Example:

RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# neighbor ipv6 1111:2222::cdef pw-id

Specifies the peer with which to cross connect, and configures the pseudowire segment for the cross-connect.

Step 7 l2tp static

Example:

RP/0/RSP0/CPU0:router (config-l2vpn)#

Enters L2TP static configuration submode.

Step 8 Use the commit or end command.

commit - Saves the configuration changes and remains within the configuration session.

end - Prompts user to take one of these actions:

• Yes - Saves configuration changes and exits the configuration session.

• No - Exits the configuration session without committing the configuration changes.

• Cancel - Remains in the configuration mode, without committing the configuration changes.

Enabling TOS Reflection in the L2TPv3 Header

Perform this task to enable the type of service (TOS) reflection in the L2TPv3 header.

SUMMARY STEPS

1. configure

2. l2vpn

3. pw-classclass-name

4. encapsulation l2tpv3

5. protocol l2tpv3

6. neighbor ipv6peer-address pw-id pseudowire-id

7. tos { reflect | value }

8. endorcommit

DETAILED STEPS

Step 1 configure

Example:

RP/0/RSP0/CPU0:router# configure

Enters global configuration mode.

Step 2 l2vpn

Example:

RP/0/RSP0/CPU0:router (config)# l2vpn

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

161

Implementing Point to Point Layer 2 Services

Enabling TOS Reflection in the L2TPv3 Header

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series